Wait a few seconds to allow the puncture site to
open so that a drop of blood can form. Apply the
blood drop to the test strip. Then carry out the test
according to the instructions that come with the
test strips or meter.
7. To remove the lancet, pull off the Accu-Chek
Softclix finger pricker cap. To eject the used lancet
slide the ejector forward to remove it, and dispose
of the lancet in a sealed container.
To avoid infections use a new lancet each
time you take a blood sample.
Using each lancet only once helps ensure
virtually pain free blood sampling.
Selecting the Puncture Site
The best place to take capillary blood is from the
side of a fingertip as it has the best blood supply and
registers the least pain.
Preparing Fingertip or Earlobe
Wash your hands in warm water and dry them well.
This helps ensure proper hygiene and stimulates
blood flow, since the drop may be too small if the
finger to be pricked is too cold or circulation is poor.
In addition, massage the finger or earlobe before
pricking.
64
To Next Page
Loading...
Need help?
General
