3-18 Machine Maintenance Procedures
WLAN (Wireless Local Area Network) Module Removal 0
Prerequisite:
Base Cover Removal
1. Find the WLAN module (C). Refer to Figure 3-10.
2. Disconnect main (A) and auxiliary (B) antenna cables from module (Figure 3-15).
Figure 3-15. WLAN Module
3. Remove one (1) screw (C) from the mainboard. Refer to Figure 3-15.
4. Remove the WLAN module from the mainboard connector (D). Refer to Figure 3-15.
WLAN Module Installation 0
1. Place the WLAN module into the mainboard connector (D). Refer to Figure 3-15.
2. Install and secure one (1) screw (C) to mainboard. Refer to Figure 3-15.
3. Install the main (A) and auxiliary (B) antenna cables on WLAN module. Refer to
Figure 3-15.
4. Install the base cover.
ID Size Quantity Screw Type
C M2.0*3.0 NI 1
To Next Page
Loading...
Need help?
General
