32
English
Channel install
Automatic search
Automatic search allows you to scan for channels. If you completed the setup wizard the
first time you turned on your TV, all available channels are listed.
Wait until the scan has finished; this will take several minutes. During the scanning
process, press MENU or BACK to abort halfway with all searched channels saved.
Automatic update
If the tuner mode is Antenna, you can use Automatic update to scan for new or deleted
channels.
Analog manual installation
You can manually add an analog channel by adjusting the settings here.
Digital manual installation
You can manually add a digital channel by searching in specific UHF channels.
Organiser
You can use these settings to skip channels, change a channels’ number and name or sort
channels.
Channel skip
Use the up/down directional keys to select a channel and press OK to check/uncheck
the box. If checked, the channel is skipped. The skipped channel can not be accessed by
pressing the CH+/- keys but can accessed by entering the channel number.
Channel sort
You can exchange two channels. Use the up/down directional keys to select a channel
and press OK to select with a tick icon. Then use the up/down directional keys to select
another channel and press OK to exchange.
Channel edit
Use the up/down directional keys to select a channel and press OK to enter the editing
menu. Use the left/right directional keys to move the cursor and the number keys to
enter channel number or channel name and press OK to save and back to the previous
menu.
Input settings
Select a type of apparatus for each connector with equipment connected.
Decode
Use the up/down directional keys to select an analog channel and press OK to decode.
Diagnostics
Display some signal information on curent digital channel.
Reset shop
Allow you to reset the TV to factory default settings. You have to enter a correct
password to reset all settings. After resetting the initial setup menu will appear.
To Next Page
Loading...
Need help?
General
