Acer X1160P User Manual

19
English
Note: "H. Position", "V. Position", "Frequency" and "Tracking" functions
are not supported under DVI or Video mode.
Note: "Sharpness" functions is not supported under DVI and Computer
mode.
Keystone Adjust image distortion caused by tilting projection. (±40 degrees)
H. Position
(Horizontal
position)
• Press to move the image left.
• Press to to move the image right.
V. Position
(Vertical position)
• Press to move the image down.
• Press to move the image up.
Frequency "Frequency" changes the projector's refresh rate to match the
frequency of your computer’s graphics card. If you can see a vertical
flickering bar in the projected image, use this function to make the
necessary adjustments.
Tracking Synchronizes the signal timing of the projector with the graphics card.
If you experience an unstable or flickering image, use this function to
correct it.
Sharpeness Adjusts the sharpness of the image.
• Press to decrease the sharpness.
• Press to increase the sharpness.

Acer X1160P Specifications

General

Number of colors	16.78 million colors
Vertical scan range	50 - 85 Hz
Horizontal scan range	31 - 69 kHz
Projection technology	DLP
Contrast ratio (typical)	2500:1
Projector native resolution	SVGA (800x600)
Aspect ratio	4:3
Dimensions (WxDxH)	267 x 80 x 187 mm
Power requirements	100 - 240 V
Connectivity technology	Wired
Lamp power	180 W
Light source type	Lamp
Service life of light source	3500 h
Service life of light source (economic mode)	4000 h
USB 2.0 ports quantity	1
Power consumption (standby)	5 W
Power consumption (typical)	255 W

Weight and Dimensions

Weight	2300 g