6. REMOTE CONTROL
Remote control of ACOM 500S is provided by either ACOM eBox Ethernet Remote Control device or RS-232
port.
6.1. Remote Control via ACOM eBox
Remote control via the ACOM eBox device is a function in development and will be
available in future firmware versions.
Remote control of ACOM 500S via the Internet is provided by the ACOM eBox Ethernet Remote Control device.
The operation of ACOM 500S with ACOM eBox will be described in future editions of the ACOM eBox User's
Manual.
Figure 6-1 | ACOM eBox Ethernet Remote Control device
Figure 6-1 | ACOM eBox Ethernet Remote Control device
Use of other remote-control devices is not recommended.
6.2. Remote Control via RS-232 interface
The ACOM 500S may be controlled remotely by the RS-232 port.
For cable connection, please see Section 2.5.b) RS-232 interface connector and Table 2-2 | Signals and pin out of
the RS-232 connector.
For ACOM 500S RS-232 interface protocol, please, contact your dealer (see Section
1.5 Owner Assistance).
To Next Page
Loading...
Need help?
General
