f) Antenna Impedance
• Nominal value: 50 Ohm unbalanced;
• Two antenna outputs available:
- RF OUTPUT 1 output provides seamless integration with the auto-switching antenna
tuners ACOM 04AT or ACOM 06AT, for access from amplifier's front panel to 4
antennas having an SWR up to 3, within 160 to 6 meter bands;
- RF OUTPUT 2 - A well-matched antenna with an SWR below 1.5 can be connected to
this output for any band. While low SWR is good for any band, it is extremely important
on 6 and 4 m. RF OUTPUT 2 is not intended for ACOM 04AT or ACOM 06AT antenna
tuners;
• Antenna connectors: PTFE UHF (SO-239A) type;
g) RF power gain
• 14 dB ±1 dB (typically 20 W drive for rated output);
h) Mains Power Supply Voltage
• 100-240 VAC ±10%, 50-60 Hz, Single phase;
See Section 7.3 Fuse Replacement for correct fuse rating and mains voltage range
selections;
i) Mains Power Consumption at Rated Output Power
• Up to 1000 VA;
• Power factor at rated output: 0.95 or higher;
j) Mains Power Consumption in Low Energy (Waiting) Mode
• Less than 1 VA;
k) Complies with CE safety and electromagnetic compatibility requirements, as well as with the
US Federal Communications Commission (FCC) regulations;
l) Size & Weight (operating, excluding connected cables)
• WxDxH: 291x270x157 mm, 7.8 kg (11.5x10.7x6.2 inches, 17.2 lbs.);
m) Operating Environments
• Temperature range: -10 to +40 degrees Celsius (14
o
F to 104
o
F);
• Relative air humidity: up to 95% @ 35 degrees Celsius (95
o
F);
• Height: up to 3050 m (10000 ft) above sea level without output deterioration.
To Next Page
Loading...
Need help?
General
