104 Agilent U1251A/U1252A User’s and Service Guide
5 Maintenance
Introduction
Repair or service which is not covered in this manual should
only be performed by a qualified personnel.
General Maintenance
Besides the above hazard, dirt or moisture in the terminals
can distort readings. The steps for cleaning are as follows:
1 Turn the meter off and remove the test leads.
2 Turn the meter over and shake out any dirt that may
have accumulated in the terminals.
3 Wipe the case with a damp cloth and a mild detergent —
do not use abrasives or solvents. Wipe the contacts in
each terminal with a clean swab dipped in alcohol.
Ensure that the terminal connections are correct for that particular
measurement before proceeding. To avoid damaging the device, do not
exceed the input limit.
To Next Page
Loading...
Need help?
General
