Alcatel-Lucent 4080 IP-DECT User Manual

Alcatel-Lucent 4080 IP-DECT
Installation Manual
8AL90850USAAed01 26
6 LEDs
6.1 LED Status
The 4080 IP-DECT is equipped with two LEDs.
LED Status (Top LED,
Yellow)
Top LED – Yellow
This LED represents the status of the 4080 IP-DECT. The indications are equal to the
status indication on the 4080 IP-DECT LED.
Meaning
Off No power
0,5 sec. On - 0,5 sec. Off Loading software/firmware
Short flash every 0,25
seconds
IP Network error (not connected, no DHCP/TFTP
server, no DAP Controller
Fast blink DAP operational, but trying to synchronize to another
DAP
Continuous fast blink Hardware error
Steady On DAP operational (and synchronized to other DAP or is
the synchronization master).
Table 1. 4080 IP-DECT LED Status on top LED
LED Status (lower LED,
Red/Green)
Lower LED – Red/Green
This LED is used to indicate the start-up and network status.
Meaning
RED Steady on Power but FPGA starting up
RED flashing Trying to connect to the network
Green flashing Network status display and showing network activity
Off 4080 IP-DECT operational
Table 2. Lower LED status on the 4080 IP-DECT.

Alcatel-Lucent 4080 IP-DECT Specifications

General

Brand	Alcatel-Lucent
Model	4080 IP-DECT
Category	Wireless Access Point
Language	English