12
AUS
Layout/Unpacking
II. Layout
1. Engine unit
2. Thread coil with trimming line
3. Protective device
3.1 Screw for protective device
4. Guide bar with drive shaft
5. Guide handle
5.1 Allen screw for guide handle
5.2 Nut for guide handle
6. On/off switch
7. Throttle interlock
8. Throttle
9. Choke lever
10. Start pull cord
11. Spark plug connector
12. Fan housing cover
13. Fuel tank
14. Housing for engine cooling
15. Fuel pump
16. Oil-fuel mixing bottle
17. Spark plug wrench
18. Allen key (4mm)
III. Unpacking
• Open the packaging and take out the equipment with care.
• Remove the packaging material and any packaging and/or transportation braces (if
available).
• Check to see if all items are present.
• Inspect the equipment and accessories for transport damage. In case of complaints the
supplier is to be informed as soon as possible.
• If possible, keep the packaging until the end of the guarantee period.
• Read the operating instructions to make yourself familiar with the device prior to using it.
• Only use original parts for accessories as well as for wearing and spare parts. Spare
parts are available from your specialized dealer.
• Specify our part numbers as well as the type and year of construction of the device in
your orders.
To Next Page
Loading...
Need help?
General
