17
AUS
Technical data/Before commissioning
Wear hearing protection.
Excessive noise can result in a loss of hearing.
Vibration A
hv
= 6.0 m/s
2
Measurement uncertainty K
PA
= 1.5 m/s
2
Keep the noise level and vibration to a minimum!
• Only use faultless products.
• Maintain and clean the product at regular intervals.
• Adapt your working methods to the product.
• Do not overload the product.
• Have the product checked if necessary.
• Switch the product off if it is not in use.
• Wear protective gloves.
VII. Before commissioning
m WARNING!
Risk to health!
Inhalation of fuel/lubricating oil vapours and exhaust gases can cause serious damage
to health, unconsciousness and in extreme cases death.
- Do not breathe fuel/lubricating oil vapours and exhaust gases.
- Only use the product outdoors.
Before each commissioning, check the product for the following:
• Leak-tightness of the fuel system.
• Faultless condition and completeness of the protective covers and the cutting device.
• Tight fit of all screw connections.
• Smooth running of all moving parts.
Fuel and oil
NOTE!
Product damage!
Usage of an incorrect engine oil and fuel mixture can cause the spark plug to become
fouled, the exhaust part to become blocked or the piston ring to become stuck.
- Follow the instructions provided in the fuel mixing table
- Use only a mixture of unleaded fuel and special 2-stroke engine oil.
- Do not use 2-stroke oil that recommends a mixing ratio of 100:1.
- Never use oil for 4-stroke engines or water-cooled 2-stroke engines.
- Failure to use the correct mixing ratio will invalidate the manufacturer’s warranty.
To Next Page
Loading...
Need help?
General
