Understanding and using these operating instructions 750W Submersible Water Pump
AFTER SALES SUPPORT
e-mail: help@powertoolsupport.com 1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290 (toll free)
10
Operating instructions and safety notes!
AFTER SALES SUPPORT
(toll free)
750W Submersible Water Pump
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
Important notes on the range of operation of the
Submersible Water Pump
• The Pump will always leave a minimum depth of water around the Pump
base of 30 - 50mm regardless of the setting of the float.
• The Pump is capable of pumping water from a depth of 7M down
to 30-50mm.
• The Pump will require a MINIMUM depth of water of 100mm to self prime
and start to pump water.
• The Pump is capable of lifting water through the outlet to a MAXIMUM
height of 8M.
• The approx. range of water depth under the operation of the oat
switch is:
- Short float cable setting: 350mm – 200 mm of water
- Long Float cable setting: 500mm – 70 mm of water
Setup / Assembly / Preparation for Operation
WARNING: Ensure the submersible Pump is disconnected from the mains
power supply before undertaking the following assembly / preparation.
WARNING: Do NOT put your hands or other body parts into the water
when the Pump is in operation and connected to the 240V mains power.
In a faulty condition, this could result in electrocution.
WARNING: Do not submerge the Pump and turn on WITHOUT connecting
a pipe to the outlet of the Pump. Failure to adhere to this point will result in
the Pump spinning and twisting the input cable and the float switch cable
creating a potential dangerous condition.
Note: Do not carry the Pump by the power cable as it will damage the
Pump and cable which will void warranty. Use the handle or carry the unit
to transport.
To Next Page
Loading...
Need help?
General
