Operating instructions and safety notes!
AFTER SALES SUPPORT
(toll free)
750W Submersible Water Pump
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
Maintenance & Cleaning
WARNING: Ensure the water Pump is disconnected from the mains power
supply before undertaking any maintenance.
To ensure a long service life, we recommend regular checks and care
of your Pump.
• If the Pump is not going to be used for a long time, rinse and empty
the unit.
• If there is a risk of frost, the Pump needs to be emptied and dry.
• If the Pump becomes blocked, remove the outlet tting and remove the
blockage if possible. If the blockage is on the input side, the 3 screws
retaining the base can be removed to remove the base and cover. Clear
the blockage from the impeller. Then replace the cover and base and the
3 assembly screws.
NOTE: DO NOT separate the lower and upper housing of the Pump.
• Before using the water Pump, always inspect it visually. Do not use the
Pump if it is cracked and/or damaged. If the water Pump is damaged, con-
tact customer service.
• Make sure that electrical connections are protected from inundations.
• Protect the plug and the power cable from heat, oil or sharp edges and
away from water and moisture.
• If damaged, the power cable must be replaced by a qualied electrician.
• If the supply cord is damaged, it must be replaced with a special cord or
assembly, available from the manufacturer or service agent.
Storage:
Ensure you store your water Pump and accessories out of childrens reach
in a dark and dry place at above freezing temperature. The ideal storage
temperature is between 5° and 30° C
To Next Page
Loading...
Need help?
General
