Operating instructions and safety notes!
AFTER SALES SUPPORT
(toll free)
750W Submersible Water Pump
e-mail: help@powertoolsupport.com1800 909 909
MODEL: №. WLBCF310 • 08/2015 • 49290
Installing the Adaptor
This adaptor can be used to fit various sizes of
pipes and fittings.
Adaptor being used to directly t Hose/
Pipe/ tube with an internal diameter of:
a) 25mm section 1 in Pic D
b) 38mm section 3 in Pic D
1. Adaptor being used to directly t hose / pipe / tube with
an internal diameter of 25mm & 38mm.
For 25mm internal diameter hoses, push the hose firmly and fully on
to section 1 of the adaptor (Pic D).
For 38 mm internal dia hoses, pass the hose over and past
sections 1 and 2 of the adaptor push the hose firmly and
fully onto section 3 of the adaptor (Pic D).
It is strongly recommended hose clamps are fitted to the
hose to retain the hose in place.
Immersing the end of the hose in hot water prior to attempting to fit the
hose “may” assist in fully fitting the hose on to section 1 or 3 of the adaptor.
2. Adaptor being used to t 25mm (1”)
tap adaptor or any other 1 inch BSP
plumbing tting:
For use with a 25mm (1”) threaded fitting, the
end of the adaptor (section 1) (9) needs to be
sawn off using a hack saw (or something similar)
to accommodate the threaded fitting to be
threaded onto the adaptor. (Pic E)
Once the end is sawn o, the adaptor can be threaded
onto the adaptor in a clockwise directon. (Pic F)
E.
D.
1 2 3
F.
To Next Page
Loading...
Need help?
General
