Alivida Sauna Controller User Manual

18
1. Meldingen en foutcodes
Error Message
Description
Possible cause
Solution
E1_1
Communicatie
problem between
controller and display
Bad connection between display and
controller
Display or controller malfunction
Reset
E2_1
Thermal protection
Controller failure
Thermal cut-out problem
Thermal cut-out position incorrect
Cable connection lost
Fix the error
+
Reset
E2_2
Temperature out of range
from 1°C / 125°C
Temperature sensor defective
Sensor cable connection broken
Reset
E3
Display defect
Overheating
Replace display
NESS
RGB Control not working
due to communication
problem between
controller and RGB box
Dip switch setting wrong. Cable
connection lost
Check installation
Service interval
It is possible to set a service interval message, which will appear in the display after a preset number
of hours has elapsed. In the low level menu go to parameter 10. Here you can adjust the value
from 0 to 100 hours with the arrow keys to the left and to the right. It is not necessary to confirm the
value in this parameter. When the number of hours set in parameter 10 has elapsed, a spanner with
screwdriver will appear in the display. This service interval message can be reset in the low level menu.
Go to parameter 10, hold the option button for 2 seconds. You will then arrive at the submenu.
Pressing and holding the aroma button for 2 seconds resets the service interval counter.
By pressing the power button you leave the low level menu.

Alivida Sauna Controller Specifications

General

Brand	Alivida
Model	Sauna Controller
Category	Controller
Language	English