40 GL4800 User Guide
Solo-In-Place
Solo-In-Place is a system for checking individual signals or combinations of signals
in the mix. This is done by muting all channels except for the channel/s being
soloed. The position and relative levels of the signal to all the outputs is retained.
Solo-In-Place affects the main outputs. This should not be confused with the
PFL/AFL monitoring system which affects only the monitor outputs. Solo-In-Place is
most useful during sound checking where you can listen to the contribution of
individual signals to the mix.
The GL4800 Solo-In-Place system lets you quickly solo selected channels using a
two key press that prevents accidental operation during a live performance. You can
toggle between your last selected solo setting and the full mix to compare the effect.
You can make selected channels 'solo safe' to prevent them being muted when
Solo-In-Place is activated. Typically you would solo safe the main outputs and the
effects returns so that the soloed channels are heard with effects. Safe channels can
be previewed and edited before operating Solo-In-Place. If not needed Solo-In-
Place can be disabled.
Using Solo-In-Place
Press and hold SOLO-IN-PLACE
The LED flashes to warn that the solo system is armed
ready for you to select a channel mute.
While holding SOLO-IN-PLACE press the mute of the channel
you want to solo.
All console mutes turn on except the selected channel
and any made 'solo safe'.
You can turn on or off other mutes while in solo mode to
hear the effect of combinations of channels.
Release SOLO-IN-PLACE
This returns the console to normal mute operation.
The previous mute settings are restored.
Last Solo
Having set up a solo combination you may wish to compare the effect
of this with the complete mix. Instead of having to repeat the selection
of the channels as above you can recall your last solo combination.
You can toggle repeatedly between this and the mix to judge the
effect.
Press SHIFT + SOLO-IN-PLACE
The last solo combination is activated.
While holding SHIFT press and release SOLO-IN-PLACE
This toggles between the last solo and the mix.
Release SHIFT or SOLO-IN-PLACE to restore normal
operation.
EDIT
SAFES
IN-PLACE
SOLO
SNAPSHOT
MIDI
CHANNEL
ACTIVE
PATCH
MODE
SHIFT
To Next Page
Loading...
Need help?
General
