26 Compact 1769-OF8C Analog Output Module
Publication 1769-IN065B-EN-P - September 2005
Hazardous Location Considerations
This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D or
non-hazardous locations only. The following ATTENTION statement applies to use
in hazardous locations.
Specification 1769-OF8C
System Power Supply Distance
Rating
The module may not be more than 8 modules away from the system power
supply.
Optional 24V dc Class 2 Power
Supply Voltage Range
(1)
20.4 V to 26.4 V dc
Recommended Cable Belden™ 8761 (shielded)
Vendor I.D. Code 1
Product Type Code 10
Product Code 40
Input Words 11
Output Words 9
Configuration Words 64
(1)
Failure to use a Class 2 power supply without regulation within these limits could result in improper module operation.
ATTENTION
EXPLOSION HAZARD
• Substitution of components may impair suitability for Class I,
Division 2.
• Do not replace components or disconnect equipment unless
power has been switched off or the area is known to be
non-hazardous.
• Do not connect or disconnect components unless power has
been switched off or the area is known to be non-hazardous.
• This product must be installed in an enclosure.
All wiring must comply with N.E.C. article 501-4(b).
To Next Page
Loading...
Need help?
General
