46 Rockwell Automation Publication 22C-UM001J-EN-E - January 2017
Chapter 2 Start Up
5. Verify that the Stop input is present or the drive will not start.
6. Verify that the Analog I/O DIP Switches are set to 10 volts.
Applying Power to the Drive
7. Apply AC power and control voltages to the drive.
8. . 8. Familiarize yourself with the integral keypad features (see page 47
)
before setting any Program Group parameters.
Start, Stop, Direction and Speed Control
Factory default parameter values allow the drive to be controlled from the
integral keypad. No programming is required to start, stop, and control speed
directly from the integral keypad.
If a fault appears on power up, refer to Fault Descriptions
on page 115 for an
explanation of the fault code.
IMPORTANT If I/O Terminal 01 is used as a stop input, the jumper between I/O Terminals
01 and 11 must be removed.
To Next Page
Loading...
Need help?
General
