Rockwell Automation Publication 5069-UM003A-EN-P - May 2018 43
Chapter 4
Configure Compact 5000 I/O Serial Module
This chapter describes how to configure your Compact 5000™ I/O serial
module in a Logix Designer application project. You can use the default
module configuration or edit the module configuration
Before You Begin
You must complete the following tasks before you can configure the module:
1. Create a Logix Designer application project.
2. If you use the Compact 5000 I/O serial module as remote I/O module,
add a Compact 5000 I/O EtherNet/IP adapter to the project.
For more information on how to add a Compact 5000 I/O EtherNet/IP
adapter to a Logix Designer application project, see the EtherNet/IP
Communication Modules in 5000 Series Systems User Manual,
publication ENET-UM004
.
TIP When a controller establishes a connection to a remote 5069-SERIAL
module, it uses a class 3 connection. We recommend that you reserve one
class 3 connection on the Compact 5000 I/O EtherNet/IP adapter to
establish a connection to the module. Otherwise, you can encounter a
“Connection Request Error: Module connection limit exceeded” error.
Topic Page
Before You Begin 43
Create a New Module 44
Edit the Module Configuration 54
View the Module Tags 69
IMPORTANT Use Studio 5000 Logix Designer® Version 31 or greater. You must install an
Add-On Profile to use the serial module. To find the Add-On Profile go to the
Product Compatibility and Download Center
(PCDC).
To Next Page
Loading...
Need help?
General
