www.amcelettronica.com 6
ENABLING INSTALLER ACCESS
ENABLING REMOTE MANAGEMENT
CODE CHANGE MENU
PROGRAMMING AND CANCELLING TAGS (PROXIMITY KEYS)
DATE / HOUR MENU
System management from display keypad
Access to the programming menu by the installer must be enabled via the personal user code. Entering the user
menu, under the item ENABLE INSTALLER ACCESS it is possible to select 1 to enable or 0 to disable the installer
to access the programming menu.
To program the control panel with the PC software, the system must be enabled. There are 2 ways to program
the control panel:
1 = local programming using the connection with USB cable and USB adapter
2 = remote programming via the Internet Cloud
Using the personal User code, enter the ENABLE TELEMANAGEMENT menu, press enter and select:
0 = to disable programming via software (ONLY possible from the keypad)
1 = to enable local programming
2 = to enable remote programming via Internet
(activating this option, the App is temporarily unavailable)
Entering the user menu, under CHANGE PERSONAL CODE, it is possible to change your code. It is important to
set the new code with the same character length as the previous one. In the event of an error, the system does
not allow the new code to be saved.
Note: with a MASTER code it is possible to modify all the codes of the users present in the control panel.
Through this menu it is possible to modify the DATE and HOUR of the system and to program daylight saving
time. Enter the menu, press ENTER and in the SETTING submenu, make the desired changes. Press ENTER again
to change the day of the week (1 for MON, 2 for TUE...0 for SUN). Press the right arrow to change day/month/
year/hour/minute in sequence. Finally confirm with ENTER.
By setting 1 in the SUMMER TIME menu, the control panel automatically adds or removes 1 HOUR, in the
envisaged periods.
A MASTER user can program the "keys" for all other users: enter the PROGRAMMING KEYS menu, confirm with
ENTER, with the UP and DOWN arrows select user, send the learning command by pressing ENTER, a time of
15 seconds will start during which the LEDs on the reader will flash, bring the tag close to the reader and when
the code is learned, the LEDs will stop flashing. The keypad will confirm successful programming on the display.
To delete, use the same procedure, but entering the DELETE KEYS menu. Once the user to be deleted has been
selected, press ENTER to confirm the deletion.
To Next Page
Loading...
Need help?
General