22
use and maintenance Area 51
722/ .,7
The tool kit is hooked to the underside of
the saddle.
To reach it, proceed as follows:
◆
Lift the saddle, see p. 21 (UNLOCK-
ING/LOCKING THE SADDLE).
The tool kit includes:
– n. 1 21 mm spark plug socket spanner
(1)
– n. 1 double-ended, cross-/cut-headed
screwdriver (2) type PH size 2 with han-
dle
– n. 1 3 mm bent hexagon spanner (3)
5($5 08'*8$5' (;7(16,21
The extension of the rear mudguard (4) is
extremely useful when the road surface is
wet, in fact it reduces the reach of the wa-
ter spray caused by the rear wheel.
The rear mudguard extension (4)
is supplied as standard equip-
ment and is positioned in the crash hel-
met / glove compartment.
For the installation, proceed as follows:
◆
Raise the saddle, see p. 21 (UNLOCK-
ING/LOCKING THE SADDLE).
◆
Remove the rear mudguard extension
(4) together with the screws and the rele-
vant fastening nuts from the crash hel-
met / glove compartment.
◆
Unscrew and remove the screw (5).
◆
Position the rear mudguard extension (4)
inside the number plate-holder support
(6).
◆
Moderately tighten the screw (5).
Only for
: the three screws (7)
and the relevant nuts serve also
for the fastening of the number plate.
◆
Insert the three screws (7) and screw
the relevant nuts.
◆
Insert the two screws (8) and screw the
relevant nuts.
◆
Make sure that the rear mudguard exten-
sion (4) is positioned correctly.
◆
Tighten the screw (5).
◆
Tighten the three screws (7).
◆
Tighten the two screws (8).
To Next Page
Loading...
Need help?
General