53
use and maintenance Area 51
$'-867,1*
7+( 9(57,&$/ +($'/,*+7 %($0
To rapidly check the correct direction of the
beam, place the vehicle on flat ground, 10
m away from a wall.
Turn on the low beam, sit on the vehicle
and make sure that the beam projected on
the wall is slightly under the horizontal line
of the headlight (about 9/10th of the total
height).
To adjust the headlight beam:
◆
Act on the suitable screw (1) by means
of a screwdriver.
By TURNING IT CLOCKWISE, you set
the beam upwards.
By TURNING IT ANTICLOCKWISE, you
set the beam downwards.
%8/%6
Carefully read p. 35 (MAINTENANCE).
Before changing a bulb, position
the vehicle on the centre stand
and turn the ignition switch to
position “
”.
Change the bulb wearing clean gloves
or using a clean and dry cloth.
Do not leave fingerprints on the bulb,
since these may cause its overheating
and consequent breakage. If you touch
the bulb with bare hands, remove any
fingerprint with alcohol, in order to pre-
vent it from blowing frequently.
DO NOT FORCE THE ELECTRIC CA-
BLES
Before changing a bulb, check
the fuse, see p. 52 (CHANGING
THE FUSE).
To Next Page
Loading...
Need help?
General