56
use and maintenance Area 51
&+$1*,1*
7+( 5($5 /,*+7 %8/%
Carefully read p. 53 (BULBS).
The rear light contains:
◆
A parking light/stoplight bulb (1).
◆
Two rear direction indicator bulbs (2).
To change them:
Support the protection screen
(4) and the coloured screen
frame (5) to prevent them from falling
down and avoid any damage.
◆
Unscrew and remove the three screws
(3).
◆
Remove the protection screen (4).
◆
Remove the coloured screen frame (5).
If necessary, the coloured
screens can be removed from
their frame (5). Slightly push them out
of their seats (from the inside towards
the outside) and change them if neces-
sary.
◆
Slightly press the bulb and rotate it anti-
clockwise.
◆
Remove the bulb from its seat.
Insert the bulb in the socket,
making the two bulb pins coin-
cide with the relevant guides on the
socket.
◆
Correctly install a new bulb of the same
type.
Upon reassembly, position the
protection screen (4) and the col-
oured screen frame (5) correctly in their
seats.
Tighten the screw (3) carefully, without
exerting too much pressure, in order to
avoid damaging the protection screen.
&+$1*,1* 7+( 180%(5 3/$7(
%8/%
,1j
Carefully read p. 53 (BULBS).
To change the bulb:
Do not pull the electric wires to
extract the bulb socket.
◆
Grasp the bulb socket (6), pull it and re-
move it from its seat.
◆
Withdraw the bulb (7) and replace it with
a new one of the same type.
To Next Page
Loading...
Need help?
General