17
use and maintenance Area 51
SWITCHING FROM KILOMETRES (km/h)
TO MILES (MPH) FOR THE
ONLY
◆
Turn the ignition switch to position “
”
(11) .
◆
Keep the MODE push button pressed
while turning the ignition switch to posi-
tion “
” (12).
For the reverse switching, repeat
these operations.
SETTING THE CLOCK
(HOURS AND MINUTES)
◆
Press the MODE push button for more
than three seconds, the segments corre-
sponding to the hours (13) will blink.
If the SET push button is
pressed and released, the data
are changed one by one, while if the
SET push button is kept pressed, the
data flip over in cyclical sequences.
◆
Press the SET push button and select
the desired hour.
◆
To confirm the hour setting, press the
MODE push button for less than three
seconds: the segment corresponding to
the tens of minutes (14) will blink.
◆
Press the SET push button and select
the desired figure for the tens of minutes.
◆
To confirm the setting of the tens of min-
utes, press the MODE push button for
less than three seconds: the segment
corresponding to the minutes (15) will
blink.
◆
Press the SET push button and select
the desired minutes.
◆
To confirm the minute setting, press and
release the MODE push button.
To Next Page
Loading...
Need help?
General