APRILIA GULLIVER 50 - 03-1999 User Manual

42
use and maintenance Gulliver 50
&2/.47(%%,
DISASSEMBLY
Carefully read page 37 (MAINTE-
NANCE).
While disassembling the wheel,
be careful not to damage the
brake pipe, the disc and the
pads.
To remove the front wheel, proceed as fol-
lows:
◆
Position the vehicle on the stand.
Place a support under the vehi-
cle, so that the front wheel has
enough space to move and the
vehicle cannot fall down.
◆
Loosen the screw of the wheel pin clamp
(1).
◆
Lock the wheel pin (2) by means of an
hexagon spanner.
◆
Remove the nut (3), taking the washer.
◆
Push the pin (2), using a rubber hammer
if necessary.
Check the arrangement of the
parts, washers and spacer ring
in order to be able to reassemble them
correctly.
◆
Support the front wheel and extract the
wheel pin manually.
◆
Remove the wheel, extracting the disc
from the brake calliper with care.
◆
Disconnect the tang of the speedome-
ter/odometer control (4).
Never pull the front brake lever
after removing the wheel, other-
wise the calliper pistons may go
out of their seats, thus causing the out-
flow of the brake fluid.
In this case consult your APRILIA Official
Dealer, who will carry out the proper
maintenance operation.
◆
Take the washer and the spacer ring.
a
a
c
a

APRILIA GULLIVER 50 - 03-1999 Specifications

General

Brand	APRILIA
Model	GULLIVER 50 - 03-1999
Category	Scooter
Language	English