41
use and maintenance Rally 50
REASSEMBLY
Carefully read page 35 (MAINTENANCE).
While reassembling the wheel, be
careful not to damage the brake
pipe, the disc and the pads.
To reassemble the front wheel, proceed as
follows:
◆
Position the wheel between the fork
rods, carefully inserting the disc in the
brake calliper.
◆
Position the odometer control tang (4) in
the apposite seat in the wheel hub.
◆
Position the plate (5), inserting its seats
in correspondence with the special anti-
rotation pins (6) and (7) situated on the
fork and on the odometer control.
◆
Insert the pin (2) from the right side of the
vehicle (direction of travel).
◆
Insert the spacer ring between the hub
and the left fork rod.
◆
Insert the washer, lock the rotation of the
wheel pin (2) by means of an hexagon
spanner and screw and tighten the nut
(3).
Wheel pin nut driving torque:
50 Nm (5 kgm).
◆
With pulled front brake lever, press the
handlebar repeatedly, thrusting the fork
downwards.
In this way the fork rods will properly bed
in.
◆
Tighten the wheel pin clamp screw (1).
After reassembly, pull the front
brake lever repeatedly and
check the correct functioning of
the braking system.
Check the wheel centering.
Have the driving torques, centering and
balancing of the wheel checked by your
APRILIA Official Dealer, in order to avoid
accidents that may be harmful for you
and/or other people.
a
To Next Page
Loading...
Need help?
General
