Ariel JGR/4 User Manual

FOR MODELS: JGW, JGR AND JGJ SECTION 3 - START UP
PAGE 3 - 2 1/01
Start-Up Check List
For latest available starp Up Check List, see ER-10.4.0 at www.arielcorp.com.
Compressor Model_____________________ Serial No. F-_________________________
Cylinder S/N C-_______ C-_______ C-_______ C-_______ C-________ C-________
Driver ______________________________ Rated Speed ________________________
Packager ____________________________ Packager Unit No. ____________________
Date Packager Shipped ________________ Start Up Date ________________________
Serviceman __________________________ Customer ___________________________
Location ____________________________ Field Contact ________________________
Field Telephone No. ___________________ Unit Location ________________________
Frame Oil - Make/Grade______________________ ________________________
Cylinder Oil - Make/Grade ______________________
Check List - Prior To Starting YES NO
1. Are the correct Ariel parts book, technical manual, special
tools, and spares available? ______ ______
2. Have the design limitations for the compressor model such as
rod load, maximum and minimum speed, discharge temperature
been checked? ______ ______
3. Have the design operating conditions been determined? ______ ______
Pressure, PSIG (kPa): Suction __________ Discharge_________
Temperature, °F (°C): Suction _______ Discharge_______
Maximum RPM__________ Minimum RPM___________
4. Soft Foot Check: Have the compressor feet and crosshead guide
supports been shimmed so the machine is not twisted or bent? ______ ______
5. Have bottom crosshead clearances on all corners been checked? ______ ______
Maximum 0.0015” (0.038 mm) feeler inserted to 1/2” (12.7 mm) maximum depth
6. Record top crosshead minimum feeler clearance below. Throw #
1______ 2______ 3_______ 4_______ 5_______ 6_______
7. Have the piping and supports been checked to be sure they do
not bend or stress compressor? ______ ______
8. Have coupling bolt torque values been rechecked? ______ ______
9. Has the compressor to driver alignment been checked? ______ ______
Maximum allowable 0.005 inches (0.13 mm) TIR
10. Record coupling dial indicator readings in inches at the
3, 6, 9 & 12 o’clock positions on lines provided:
11. Has the crankshaft thrust clearance been checked? ______ ______
Record crankcase thrust clearance here: inches (mm)
Face
Rim

Ariel JGR/4 Specifications

General

Brand	Ariel
Model	JGR/4
Category	Air Compressor
Language	English