Assa Abloy Norton D6001DE-R Double Unit Series User Manual

Copyright © 2019-2020, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9360-1035-020 Rev 3 03/20
11
D6001DE-R Double Unit Series (Double Egress) Power Operator
B. Install Arm Assembly To Track.
1. Open left door.
2. Using an adjustable wrench, rotate
top pinion 45 degrees toward door
hinge. You will feel resistance from
spring. (Figure 21)
3. While holding pinion at 45 degrees,
slide arm on bottom pinion parallel
to frame as shown. (Figure 21)
NOTE: Pinion at should be aligned
as shown. (Figure 22)
4. Secure arm to pinion with 1/4-20 x
1/2" screw and countersunk patch
washer. (Figure 21)
5. Insert stud on arm into slider in track
by pressing clip on backside of slider
onto stud. (Figure 23)
6. To adjust track stop:
• Use Allen wrench to loosen set
screw in bumper stop.
• Open door to full open position.
• Slide bumper stop until it just
touches end of slider.
• Tighten set screw in bumper stop
so bumper will stay in position.
(Figure 24)
A. Mount Track.
1. Using previously prepared holes in
left door, install three (3) 1/4-20 x
1-5/8" screws through track and into
sex bolts. (Figure 19)
NOTE: (Figure 20)
• Opening of track is toward top
of door.
• Adjustable bumper stop is toward
hinge edge of door.
Install Track and Arm to Left Door
Adjustable Bumper Stop
Track Opening
Figure 19
Figure 20
Figure 21
Figure 22
Figure 24
Figure 23

Assa Abloy Norton D6001DE-R Double Unit Series Specifications

General

Brand	Assa Abloy
Model	Norton D6001DE-R Double Unit Series
Category	Garage Door Opener
Language	English