ROG Blitz Formula 4-15
If you want the Serial ATA hard disk drives to use the Advanced Host Controller
Interface (AHCI), set this item to [AHCI].
Hard Disk Write Protect [Disabled]
Disables or enables device write protection. This will be effective only if device is
accessed through BIOS.
Conuration option: [Disabled] [Enabled]
IDE Detect Time Out (Sec) [35]
Selects the time out value for detecting ATA/ATAPI devices.
Conguration options: [0] [5] [10] [15] [20] [25] [30] [35]
4.3.7 AHCI Conguration
This menu allows you to congure AHCI settings. It appears only when you set the
Congure SATA as item to [AHCI] in the SATA Conguration menu.
AHCI Settings
AHCI Port1 [Not Detected]
AHCI Port2 [Not Detected]
AHCI Port3 [Not Detected]
AHCI Port4 [Not Detected]
AHCI Port5 [Not Detected]
AHCI Port6 [Not Detected]
While entering setup,
BIOS auto detects
the presence of SATA
devices. This displays
the status of auto
detection of SATA
devices.
ACHI Port1~6 [XXXX]
Displays the status of auto-detection of IDE devices.
AHCI Port1
Device :Not Detected
SATA Port1 [Auto]
Select the type of
devices connected to
the system.
SATA Port1 [Auto]
Allows you to select the type of device connected to the system.
Conguration options: [Auto] [Not Installed]
To Next Page
Loading...
Need help?
General
