49
4. To set up WPS using the router’s WPS button, follow these
steps:
a. Click Start or press the WPS button found at the rear of the
xDSL modem router.
b. Press the WPS button on your wireless device. This is
normally identified by the WPS logo.
NOTE: Check your wireless device or its user manual for the location of
the WPS button.
c. The xDSL modem router will scan for any available WPS
devices. If the xDSL modem router does not find any WPS
devices, it will switch to standby mode.
5. To set up WPS using the Client’s PIN code, follow these steps:
a. Locate the WPS PIN code on your wireless device’s user
manual or on the device itself.
b. Key in the Client PIN code on the text box.
c. Click Start to put your xDSL modem router into WPS survey
mode. The router’s LED indicators quickly flash three times
until the WPS setup is completed.
To Next Page
Loading...
Need help?
General
