4-26 Chapter 4: BIOS setup
IRQ-xx assigned to [PCI Device]
When set to [PCI Device], the specific IRQ is free for use of PCI/PnP
devices. When set to [Reserved], the IRQ is reserved for legacy ISA
devices. Configuration options: [PCI Device] [Reserved]
4.4.5 MPS Configuration
The items in this menu allows you to configure the Multi-Processor Table.
Select an item then press <Enter> to display the configuration options.
MPS Revision [1.4]
Allows you to select the multi-processor system revision.
Configuration options: [1.1] [1.4]
MPS Configuration
MPS Revision [1.4]
Select MPS Revision.
4.4.6 Remote Access Configuration
The items in this menu allows you to configure the Remote Access
features. Select an item then press <Enter> to display the configuration
options.
Configure Remote Access type and parameters
Remote Access [Enabled]
Serial port number [COM1]
Base Address [3F8h, 4]
Serial Port Mode [115200 8,n,1]
Flow Control [None]
Redirection After BIOS POST [Always]
Terminal Type [ANSI]
VT-UTFB Combo Key Support [Enabled]
Media Type [Serial]
Select Remote Access
type.
Remote Access [Enabled]
Enables or disables the remote access feature.
Configuration options: [Disabled] [Enabled]
To Next Page
Loading...
Need help?
General
