2-20
Chapter 2: BIOS Setup
Secondary Slave as RAID [Disabled]
Enables or disables the use of the Secondary IDE Slave as RAID.
Configuration options: [Disabled] [Enabled]
Third Master as RAID [Disabled]
Enables or disables the use of the Third IDE Master as RAID.
Configuration options: [Disabled] [Enabled]
Fourth Master as RAID [Disabled]
Enables or disables the use of the Fourth IDE Master as RAID.
Configuration options: [Disabled] [Enabled]
USB Configuration
The items in this menu allows you to change the USB-related features. Select an
item then press <Enter> to display the configuration options.
The Module Version and USB Devices Enabled items show the auto-detected
values. If no USB device is detected, the item shows None.
USB Configuration
Module Version - 2.23.2-7.4
USB Devices Enabled: None
USB Controller Support [USB 1.1+USB 2.0]
Legacy USB Support [Auto]
USB 2.0 Controller Mode [HiSpeed]
Enables USB
host controllers.
USB Controller Support [USB 1.1+USB 2.0]
Allows you to disable or set the USB controller support type.
Configuration options: [Disabled] [USB 1.1 only] [USB 1.1+USB 2.0]
Legacy USB Support [Auto]
Allows you to enable or disable support for legacy USB devices. Setting to Auto
allows the system to detect the presence of USB devices at startup. If detected,
the USB controller legacy mode is enabled. If no USB device is detected, the
legacy USB support is disabled. Configuration options: [Disabled] [Enabled] [Auto]
USB 2.0 Controller Mode [HiSpeed]
Allows you to configure the USB 2.0 controller in HiSpeed (480 Mbps) or Full
Speed (12 Mbps). Configuration options: [HiSpeed ] [Full Speed]
To Next Page
Loading...
Need help?
General
