To update the BIOS using EZ Flash 2:
the motherboard.
3. You can launch the EZ Flash 2 by two methods.
2.1.2 ASUS EZ Flash 2 utility
The ASUS EZ Flash 2 feature allows you to update the BIOS without having to go
utility. The EZ Flash 2 utility is built-in the BIOS chip so it is accessible by pressing
<Alt> + <F2> during the Power-On Self-Test (POST).
(2) Enter BIOS setup program. Go to the Tools menu to select EZ Flash2
and press <Enter> to enable it.
is found. Then press <Enter>.
(1)
Press <Alt> + <F2> during POST to display the following.
with
FAT 32/16
format only.
• Do not shut down or reset the system while updating the BIOS to prevent
system boot failure!
process and automatically reboots the system when done.
ASUSTek EZ Flash 2 BIOS ROM Utility V3.00
Current ROM
Update ROM
A:
Note
[Enter] Select or Load [B] Backup [ESC] Exit
[Tab] Switch [Up/Down/Home/End] Move
FLASH TYPE: SST 49LF008 FWH
PATH: A:\
BOARD: M2N-VM
VER: 0107 [0101]
DATE: 12/21/06
BOARD: Unknown
VER: Unknown
DATE: Unknown
To Next Page
Loading...
Need help?
General
