3-18
Chapter 3: BIOS Setup
Chapter 3
3.6.7 ROG Effects
The items in this menu allow you to congure the LEDs on your motherboard and the
functions for the Q-Code LED.
Onboard LED
This item allows you to enable all the onboard LEDs.
Conguration options: [Enabled] [Disabled]
Q-Code LED Function
[Auto] Automatically display POST (Power-On Self-Test) code and CPU
temperature on Q-Code LED.
[POST Code Only] Show POST (Power-On Self-Test) code on Q-Code LED.
3.6.8 Onboard Devices Configuration
The items in this menu allow you to switch between PCIe Lanes and congure onboard
devices.
HD Audio Controller
This item allows you to use the Azalia High Denition Audio Controller
Conguration options: [Disabled] [Enabled]
M.2_1 Configuration: [Auto][SATA mode][PCIE mode]
[Auto] Auto-detects the M.2 device mode. If a SATA device is detected,
SATA6G_1 will be disabled.
[SATA mode] Only supports M.2 SATA devices. Please note that SATA6G_1 port cannot
be used in this mode.
[PCIE mode] Only supports M.2 PCIE devices.
M.2_2 PCIe Bandwidth Configuration: [X2][X4]
[X2] Run at X2 mode with SATA6G_56 enabled.
[X4] Run at X4 mode for higher performance with SATA6G_56 disabled.
3.6.6 PCH-FW Configuration
This item allows you to congure the rmware TPM.
SATA6G_1(Gray) - SATA6G_6(Gray)
SATA6G_1(Gray) - SATA6G_6(Gray)
This item allows you to enable or disable the selected SATA port.
Conguration options: [Disabled] [Enabled]
Hot Plug
These items appears only when the SATA Mode Selection is set to [AHCI] and allows
you to enable or disable SATA Hot Plug Support.
Conguration options: [Disabled] [Enabled]
To Next Page
Loading...
Need help?
General
