5-24
Chapter 5: Software support
5.4.6 Reset RAID Data
1. Select option 3 Reset RAID Data and press the <Enter> key to
delete the RAID set and remove any RAID structures from the
drives.
[
DISK/VOLUME INFORMATION
]
RAID Volumes:
None defined.
Non-RAID Disks:
Port Drive Model Serial # Size Status Bootable
0 ST320413A xxxxxxxx 18.6GB Normal Yes
1 ST320413A xxxxxxxx 18.6GB Normal Yes
Intel(R) Integrated RAID for Serial ATA - RAID Configuration Utility
Copyright(C) 2003 Intel Corporation. All Rights Reserved. v3.x.x.xxxx
[
MAIN MENU
]
1. Create RAID Volume
2. Delete RAID Volume
3. Reset Disks to Non-RaID
4. Exit
[ ]-Select
[ESC] Exit
[Enter]-Select Menu
2. Confirm the volume deletion by pressing the <Y> key.
Take caution in using this option; All data on the RAID drives and any
internal RAID structures will be lost!
Resetting all RAID data will remove any internal RAID structures
from all RAID disks, including disks with working volumes. These
structures are used to maintain the RAID volumes. By removing
these structures, the drive will revert back to a Non-RAID disk
that can then be used or reallocated to a new RAID volume.
[
RESET ALL DATA RAID DATA
]
WARNING: Selecting "Yes" will cause all data on any RAID disk
(RAID Volume or Other RAID Disk) to be lost.
Are you sure you want to destroy all RAID data (Y/N):
1. Select option 2 Delete RAID Volume and press the <Enter> key to
delete the RAID set.
2. Press the <Delete> key to delete the RAID volume.
Are you sure you want to delete this volume?
ALL DATA IN THE VOLUME WILL BE LOST!!
Are you sure you want to delete volume "RAID_Volume1"? (Y/N)
[
VOLUME DELETE VERIFICATION
]
3. Confirm the volume deletion by pressing the <Y> key.
To Next Page
Loading...
Need help?
General
