2-14
Chapter 2: Hardware information
2.5.3 Installing a DIMM
Follow these steps to install a DIMM.
1. Locate the DIMM sockets in the
motherboard.
2.5.4 Removing a DIMM
Follow these steps to remove a DIMM.
4. Firmly insert the DIMM into the
socket until the retaining clips
snap back in place and the DIMM
is properly seated.
1. Simultaneously press the
retaining clips outward to unlock
the DIMM.
2. Remove the DIMM from the socket.
2. Unlock a DIMM socket by
pressing the retaining clips
outward.
3. Align a DIMM on the socket such
that the notch on the DIMM
matches the break on the socket.
P4P800
P4P800 184-Pin DDR DIMM Sockets
80 Pins104 Pins
DIMM_A
DIMM_A
DIMM_B
DIMM_B
Make sure to unplug the power supply before adding or removing
DIMMs or other system components. Failure to do so may cause
severe damage to both the motherboard and the components.
A DDR DIMM is keyed with a notch so that it fits in only one direction.
DO NOT force a DIMM into a socket to avoid damaging the DIMM.
Support the DIMM lightly with your fingers when pressing the retaining
clips. The DIMM might get damaged when it flips out with extra force.
Unlocked Retaining Clip
DDR DIMM
Locked Retaining Clip
To Next Page
Loading...
Need help?
General
