4-28 Chapter 4: BIOS setup
CPU0/1 Fan Speed [xxxxRPM] or [Ignored] / [N/A]
The onboard hardware monitor automatically detects and displays the CPU
fan(s) speed in rotations per minute (RPM). If the fan is not connected to the
motherboard, the eld shows [N/A].
Chassis Fan1/2/3/4 Speed [xxxxRPM] or [Ignored] / [N/A]
SPS Fan1 Speed [xxxxRPM] or [Ignored] / [N/A]
FBD Fan1 Speed [xxxxRPM] or [Ignored] / [N/A]
The onboard hardware monitor automatically detects and displays the chassis ,
SPS, and FBD fan speed in rotations per minute (RPM). If the fan is not connected
to the motherboard, the eld shows [N/A].
Smart Fan Control [Enabled]
Allows you to enable or eisable the Smart Fan Control.
Conguration options: [Disabled] [Enabled]
CPU0/1 Target Temperature [55]
CPU fan 0 or 1 will operate at the maximum speed when CPU 0 or 1 reaches this
target temperature.
Conguratino options: [50] ~ [70]
MB Target Temperature [45]
System fan will operate at the maximum speed when system reaches this target
temperature.
Conguratino options: [35] ~ [55]
VCORE0/1 Voltage, VTT Voltage, FBD +1.5V Voltage, FBD +1.8V
Voltage, 3V Voltage, 12V Voltage, 5V Voltage, 5VSB Voltage, VBAT
Voltage
The onboard hardware monitor automatically detects the voltage output through
the onboard voltage regulators. Select [Ignored] if you do not want to detect these
items.
4.5.7 PSMI IPMI FRU
Shows the product information.
To Next Page
Loading...
Need help?
General
