Moil point
The moil point is only used for
making holes in concrete and
other types of hard materials.
Wide bladed chisel
The wide bladed chisel is
used in soft materials, such as
asphalt and frozen ground.
Spiking tool
The spiking tool is used for
spikes and tent poles in soft
materials, such as asphalt and
frozen ground.
WARNING Vibration hazard
Using inserted tools that do not fulfil the criteria
mentioned below, will result in a longer time to
complete a task, and may result in higher levels of
vibration exposure. A worn tool will also cause
increased working time.
►
Make sure that the inserted tool is well-
maintained, not worn out and of the proper size.
►
Always use a sharp tool in order to work
efficiently.
Checking for wear on the tool shank
Use the gauge that corresponds to the insertion
tool’s shank dimension. See section "Technical
data" for correct tool shank dimensions.
•
Check if the gauge’s hole (A) can be pushed
down on the insertion tool’s shank, this means
that the shank is worn out and the insertion tool
should be replaced.
•
Check the length (B), that it is according to the
ordered machine type.
Operation
WARNING Involuntary start
Involuntary start of the machine may cause injury.
►
Keep your hands away from the start and stop
device until you are ready to start the machine.
►
Learn how the machine is switched off in the
event of an emergency.
Start and stop
Starting
◆
Remove the fuel cap and check the fuel level.
Secure the fuel cap before start.
1. Press the decomp knob located at the right
side of the front cover.
2. Pump at least five times on the primer pump.
3. Pull the starter handle. Never release the
starter handle until it reaches the starter cover.
If the machine starts but then stops. Press the
decomp knob. Pull the starter handle.
◆
Let the engine run for 1-2 minutes with the
throttle lever slightly pressed before use. Full
performance will be reached after
approximately 5 minutes of use.
Stopping
◆
Stop the machine by pushing the stop button
(on the right handle) forwards, until the engine
stops.
Safety and operating instructions COBRA PROi
14 © Construction Tools PC AB | 9800 1758 01 | 2017-01-10
Original instructions
To Next Page
Loading...
Need help?
General
