When a service plan interval is reached, a message will appear on the screen; see section Status
data menu. After carrying out the service actions related to the indicated levels, the timers must
be reset.
Example
Service plans Intervals
Service plan A Every 4000 running hours
Service plan B Every 4000 running hours
Service plan C Every 8000 running hours
Service plan D Every 24000 running hours
Resulting service actions according to At
Service plan A and B 4000 running hours
Service plan A, B and C 8000 running hours
Service plan A and B 12000 running hours
Service plan A, B and C 16000 running hours
Service plan A, B, C and D 24000 running hours
... ...
Procedure
Starting from the Main screen (see Main screen menu):
• Press the key ‘Menu’ (F1).
• Press the arrow down key (1) until ‘Service’ is followed by a horizontal arrow.
• Activate the menu by pressing tabulator key (2).
• A screen similar to the one below appears:
‘Service Timer’
‘Running Hours’
‘hrs’ 7971
‘Menu’
F1 F2 F3
• The screen shows that the total compressor running time is 7971 hours.
• Press the tabulator key (2); the following screen appears:
‘Next Timer’
‘Level’ A B C
‘hrs’ 8000
‘Back’ ‘Rset’
F1 F2 F3
• The screen shows that the next service plans to be carried out are plans A, B and C and that
these plans are to be carried out every 8000 running hours.
Instruction book
40 API161475
To Next Page
Loading...
Need help?
General
