Qualification
Transporting the hydraulic attachment is only
permitted if carried out by people who:
● are authorised to operate a crane or a forklift truck
according to the applicable national provisions,
● know all the relevant national/regional safety
provisions and accident prevention rules,
● have read and understood the safety and transport
chapter of these Safety and operating instructions.
Installing, maintaining, storing and disposing of
the hydraulic attachment are only permitted if carried
out by people who:
● know all the relevant national/regional safety
provisions and accident prevention rules,
● have read and understood these Safety and
operating instructions.
Operating the hydraulic attachment is only permitted
if carried out by qualified carrier drivers. Carrier
drivers are qualified if they:
● have been trained to operate a carrier according
to the national regulations,
● know all the relevant national/regional safety
provisions and accident prevention rules,
● have read and understood these Safety and
operating instructions.
Testing the hydraulic installation is only permitted
if carried out by professionals. Professionals are
people who are authorised to approve a hydraulic
installation for operation according to the national
regulations.
Repairing the hydraulic attachment is only permitted
if carried out by professionals trained by Atlas Copco
Construction Tools. These professionals must have
read and understood these Safety and operating
instructions. They must follow all safety instructions
and guidelines for repair. Otherwise the operational
safety of the hydraulic attachment is not guaranteed.
Intended use
Only attach the hydraulic breaker to a hydraulic
carrier of a suitable load-bearing capacity.
Only use the hydraulic breaker function of the device
to break or fragment concrete, stone and rocks.
Using the hydraulic breaker in and under water, in
tunnels, under the ground and for hot applications is
only possible if it has been fitted out with special
safety equipment.
Intended use also implies observing all instructions
in these Safety and operating instructions.
Use other than intended
Never operate the hydraulic breaker in an
environment where there is a risk of explosions.
Explosions will result in serious injury or death.
Never use the hydraulic breaker
● to transport or lift objects.
The lifted object can fall and cause serious injuries
or death.
● as a sledge hammer.
This will damage the hydraulic breaker, the
working tool and the carrier.
● as a crowbar.
This can cause the working tool to break.
● to push debris
This damages the hydraulic breaker.
Protective equipment
Personal protective equipment must comply with the
applicable health and safety regulations.
Always wear the following personal protective
equipment:
● protective helmet
● safety glasses with side protectors
● protective gloves
● protective shoes
● warning vest
● hearing protection
© 2012 Atlas Copco Construction Tools GmbH | No. 3390 5005 01 | 2012-05-03
Original instructions
10
HB 5800, 5800 DP, 7000, 7000 DP, 10000 DPSAFETY INSTRUCTIONS
To Next Page
Loading...
Need help?
General
