CD adsorption dryer
Heavy duty air inlet filter
Oil level switch
N.O. (normally open contact) Break contact
N.C. (normally closed contact) Make contact
Receiver wheel set 90 and 250 liters horizontal receivers
Power supply cable
(3 m)
with CEE 3 pole plug 16 Amp
Auto restart to start unloaded after power failure
Timer drain
(solenoid operated)
to remove condensate from receiver
2.3 Air flow
LT units
Air drawn through air filter (AF) and inlet silencer (1) into LP (low-pressure) cylinder(s) (2) is compressed,
then discharged to HP (high-pressure) cylinder (3) via intercooler (Ci).
The air is compressed further and discharged through cooler piping (5) and check valve (CV) into air receiver
(AR).
Instruction book
2920 7089 90 15
To Next Page
Loading...
Need help?
General
