Atlas Copco WEDA 30 User Manual

- 8 -
AUTHORISED PERSONNEL
Only people that have the right skills should be
allowed to operate, adjust, perform maintenance or
repair on Atlas Copco equipment.
It is the responsibility of management to appoint
operators with the appropriate training and skill for
each category of job.
Skill level 1: Operator
An operator is trained in all aspects of operating the
unit with the push-buttons, and is trained to know the
safety aspects.
Skill level 2: Mechanical technician
A mechanical technician is trained to operate the unit
the same as the operator. In addition, the mechanical
technician is also trained to perform maintenance and
repair, as described in the instruction manual, and is
allowed to change settings of the control and safety
system. A mechanical technician does not work on
live electrical components.
Skill level 3: Electrical technician
An electrical technician is trained and has the same
qualifications as both the operator and the mechanical
technician. In addition, the electrical technician may
carry out electrical repairs within the various
enclosures of the unit. This includes work on live
electrical components.
Skill level 4: Specialist from the manufacturer
This is a skilled specialist sent by the manufacturer or
its agent to perform complex repairs or modifications
to the equipment.
In general it is recommended that not more than two
people operate the unit, more operators could lead to
unsafe operating conditions.
DANGERS WHEN NOT FOLLOWING SAFETY
INSTRUCTIONS
Not observing the safety instructions may lead to
personal injury, damage to the equipment and
environmental hazards. Not observing the safety
instructions will void any warranty claim.
SAFETY-CONSCIOUS WORKING METHOD
All safety instructions in this manual as well as
national accident preventing regulations and
company-internal regulations regarding labour,
operation and safety have to be observed.
PERSONAL SAFETY
Stay alert, watch what you are doing and use common
sense when operating a pump. Do not use pumps
while tired or under influence of drugs, alcohol or
medication. A moment of inattention while operating
pumps can result in serious personal injury.
Dress properly. Do not wear loose clothing or
jewellery. Contain long hair. Keep your hair,
clothing, and gloves away from moving parts. Loose
clothes, jewellery, or long hair can be caught in
moving parts.
Use approved safety equipment. Always wear eye
protection, protective shoes and gloves.
SAFETY DURING MAINTENANCE
The owner is responsible for adequate training of the
personnel maintaining the pumps. In principle all
maintenance has to be performed on a non-energised
pump. Observe the procedures as mentioned in the
manual.
ELECTRICAL SAFETY
Pumps must be plugged into an outlet that is properly
installed and grounded in accordance with all codes
and ordinances. Never remove the grounding prong
or modify the plug in any way. Do not use any adaptor
plugs. Check with a qualified electrician if you are in
doubt as to whether the outlet is properly grounded.
Do not abuse the power cable. Never use the power
cable to carry the pumps or pull the plug from an
outlet. Keep the power cable away from heat, oil,
sharp edges or moving parts. Damaged power cables
increase the risk of electric shock.
Use a network protected by a ground fault circuit
interrupter.
CONVERSION AND SPARE PARTS
Conversions are only allowed after written consent of
the manufacturer. Always use original spare parts.
Unauthorised conversion and / or the use of non-
original spare parts will void any warranty claims.

Atlas Copco WEDA 30 Specifications

General

Brand	Atlas Copco
Model	WEDA 30
Category	Water Pump
Language	English