Audio Technica AT2020USB-X User Manual

7
Connection procedure
➊ USB conversion adapter (USB Type-A to
USB Type
-C)
➋ USB Type-A
➌ Headphone input plug
➍ USB Type-C
➎ Audio-Technica logo
1
Connect the USB cable (USB Typ e-C side) to the USB terminal on the underside of the product.
2
Connect the USB cable (USB Type-A side) to the computer.
• If necessary, use the USB conversion adapter (USB Type-A to USB Type-C) depending on the USB terminal of
the computer you are using. Use the USB conversion adapter for the USB terminal of the computer side. Do
not connect it to the USB terminal of the product side.
• If you are using Windows, refer to "Computer settings (Windows)" (p. 8) to do the settings.
• If you are using Mac, refer to "Computer settings (macOS)" (p. 38) to do the settings.
• Make sure that the mute indicator lamp lights blue (ready for audio input).
3
If you are using headphones, connect the headphones to the headphone jack.

Audio Technica AT2020USB-X Specifications

General

Cable length	2 m
Control type	Buttons, Rotary
Plug and Play	Yes
Product color	Black
Windows operating systems supported	Windows 10, Windows 11, Windows 8.1
Power source	USB
Input voltage	5 V
Device interface	3.5 mm (1/8\
USB connector type	USB Type-C
Connectivity technology	Wired
Cables included	USB Type-C to USB Type-A
Number of products included	1 pc(s)
Type	PC microphone
Bit rate	24 bit
Sample rate	96 kHz
Volume control	Rotary
Voice coil type	Dynamic
Microphone frequency	20 - 20000 Hz
Microphone Total Harmonic Distortion (THD)	1 %
Output impedance	32 Ω

Weight and Dimensions

Height	142 mm
Diameter	52 mm
Microphone weight	373 g