AUXILIARY STEREO
PREAMPLIFIER SOURCE
MP3 PLAYER
IN1
IN2
IN2
1. Using the DRC, selecting the OPTICAL input.
2. Using the appropriately set OPTICAL IN terminal
(see sec. 7.3.4.7).
This command is active connecting the terminal to + 12V.
How to select OPTICAL input:
5.3 DIGITAL OPTICAL IN INPUT SIGNALS
WARNING: The digital inputs accepts up to 96 kHz / 24 bit stereo PCM signals. So DOLBY DIGITAL (AC3) multi-channel signals
coming from audio/video sources (such as the audio of a film in DVD) or DTS can not be reproduced. The output of
these devices will therefore have to be set in STEREO mode for the signal to be reproduced. If digital signals at
frequency higher than 96kHz (Ex. 192 kHz) are supplied, the AP8.9 bit will not be able to reproduce them.
OPTICAL FIBER (see sec. 10.7; 10.8)
0
1
2
3
4
5
6
7
POWER - 12V
USB
OPTICAL SEL.
12345
123
456
76
8
UPGRADEPRESETS
SPEAKER
OUT
OPTICAL IN
DRC
SUB OUT
INPUTS
ASP
OFF ON
REM IN
REM OUT
MASTER ENABLE
30A
TOSLINK connector
PCM Stereo signal, max 96 kHz / 24 bit
ACP 2
(optional)
(see sec. 10.3)
ACP 6
(optional)
(see sec. 10.3)
ACP 2
(optional)
(see sec. 10.3)
5