By clicking on this item, a drop-down menu appears with the
entries shown in the image:
7.3.4 SETTINGS MAIN MENU
1
2
3
4
5
6
7
1. I/O Configuration Wizard: Sets up the system,
and puts AP8.9 bit in the conditions needed to be able to
perform this operation
(see sec. 7.2).
4. Working Mode: The software can work in two modes, acting on the
crossover filter section.
Standard: simplified mode with some restrictions easing the use
of the software
(see sec. 7.3.10).
Expert: there are no restrictions in the software functions of use
(see sec. 7.3.10).
3. De-Equalizer: If activated (Enabled), this function enables the
de-equalization curve calculated during the Configuration
Wizard. If the function is deactivated (Disabled) no
source de-equalization curve is applied.
The Reset command deletes the de-equalization curve
calculated during the Configuration Wizard.
6. Input configuration: Shows the specialization assigned to the inputs
on AP8.9 bit during the Configuration wizard.
2. Dynamic equalizer limiter: If activated (Enabled), this function
lets you improve the listening experience, action on the output
volume
on AP8.9 bit when heavy equalization is set, eliminating
the subsequent distortions (soft clipping).
WARNING: switching from one mode to another resets the configuration
of the filters to their original Default setting.
WARNING: Whenever performing the I/O Configuration Wizard, the values
set in the Options menu (see sec. 7.3.4.7) are set to the default values.
4
7
5. Sensitivity: Lets you display and adjust the sensitivity of AP8.9 bit inputs.
To perform the sensitivity calibration, refer to sec. 7.2.6.
To Next Page
Loading...
Need help?
General
