to SD card, you can choose "SD card".
PC memory: Your equipment need not connect to Internet and computer when
selecting this option. If you need to offline print put storage device connected to computers
first. If your computer default your storage devices for G dish you can choose "G dish", click
"ok" after completion of print parameter settings and print documents will default save to G
plate. Put your G disks connected to device motherboard and run.
Printer width :Choose your printer width according to print head breadth, input 256.
（三）File print parameter setting
① Select print documents, press the "ok".
Heating power :Adjust heating time, if the numerical is bigger the heating time is
longer. But exceed numerical will burn out the ribbon and cloth even print head. Generally
between 15-30 relate to environmental temperature, humidity and ribbon melting point.
Hot spot power: The numerical is less than five to ten, Suggest this function in print
documents longer than 1000 mm length when use, and ensuring the print head long time
heating and doesn't burn broken ribbon. This function in the use of print driver use, artcut
software not support.
Edge power: This function in the use of print driver use, artcut software not support.
Temperature control proportion :Default is 1% or 2%. Please keep default
in case of print chromatism.
Speed delay: Data transmission speed. General bigger than 5.
Repetitions: Printed times of a same file, not less than 1.
After above parameters settings were finished, press "ok", the equipment can be normal print.
② Screen displays in working process :
Filename: printing file name.
Finish: how many data were finished.
Completion times: printing times of one file.
To Next Page
Loading...
General