Save carbon and delay: Adjust saving carbon with distance
Set parameters
Language: At present support simplified Chinese character, traditional Chinese character,
English interface. According "V -" adjustment.
Print correct: Generally as the default, such as print a 500mmX500mm color piece, print the
actual size for 500mmX600mm, they can adjust the print correct numerical, if
actual length is longer than goal length, increase the target print words
correcting numerical, contrary to print decrease the value.
Empty walk correct: The distance between of two texts or the graphic. Generally default to
zero, adjust method is the same as "print correcting".
Each pulse: Adjust the paper pulse of step motor, generally to default 46.
Print head width: Set the print head width, 330 A select 256.
Preheating temperature: Set the print head preheating temperature. In general under the
10 ℃ in the environment to use the machine. Please use it carefully, use
undeserved will cause printing effect is poor or damage the print head. In
general default zero.
Preheating strength: Set temperature of heating rate In general under the 10 ℃ in the
environment to use the machine. Please use it carefully, use undeserved
will cause printing effect is poor or damage the print head. In general
default ten.
Contrast degree: Adjust LCD screen brightness, generally for default 40.
Fell head delay: Adjust the print head ups and downs of the delay time for general default
zero, but set it to one.
Into paper pulse: Adjust the forty two step motor into paper pulse, generally for default 0,
but set it to more than 4000, otherwise, it will cause the print head fall on
rubber roller to reduce the service life of the machine.
Paper length: Keep the default is zero. Make sure don't to adjust this argument, or you will
cause printing poor effect or damage the print head.
Switch to upgrade mode: Click on the "confirmation" can switch to the mainboard upgrade
mode.
Print the test design: This state click "confirm".
To Next Page
Loading...
General