www.avmatrix.net
12
4.3.3 FTB (Fade to Black)
Press FTB button it will fade the current video Program source to black. The button will flash to
indicate that it’s active. When press the button again it acts in reverse from complete black to the currently
selected Program video source, and button stop flashing. FTB is usually used for emergency condition.
Note: When the PGM window display black and keep black even after transition, please check if the FTB
button flashing. Press the button again when it is flashing to stop black.
4.3.4 Source Selection of Channel 5 and Channel 6
Press the button IN5 / IN6 to cyclic switch the video source between HDMI, DVI, VGA and USB. The
default format is HDMI. The switcher will save your last format choice when power on again.
4.3.5 USB Media Player
1) USB Media Player Setup
Plug in the USB disk input the USB port in the side panel as below image:
Setup the video source of channel 5 or 6 to USB as point 4.3.4, then manage the USB media play from
the control panel.
Press USB5 or USB6 button to select the one which you want to manage. The VIDEO/IMAGE button is
for switching the media format between video and picture. The default setting is video format when the
video switcher power on.
There are Play/Pause, Fast Forward, NEXT and BACK buttons to control the media source from USB.
The Fast Forward and Fast Backward support max 32 times speed to play the video.
To Next Page
Loading...
Need help?
General
