14
Chapter 4 Basic Operations
Other than the audio prompt beeps heard on the audio recordings, the volume/pairing button has no eect on
the audio recording captured by the camera.
Turning o the Controller LEDs
For some situations, you may wish to turn o the lights on your controller.
1 Press and hold the Battery button for 10 seconds.
• The Operation LED ashes red, yellow, and then green before shutting down the lights.
• Pressing the Battery button will momentarily light both the Operation LED and the Battery LED, displaying
the current operating mode and battery level. For interpreting the LED colors, see Axon Flex Controller in
Chapter 2: Hardware in this manual.
2 To turn the lights back on, press and hold the Battery button for 10 seconds.
If you disconnect a cable when the lights are active, the Operation LED ashes yellow. If you turned o the
LEDs, and you later disconnect a cable, there will be no visual warning that the cable has been disconnected.
To Next Page
Loading...
Need help?
General
