O
V
E
R
V
I
E
W
9
Setting Up Your Baby Lock
5. Position the telescopic thread guide.
Raise the telescopic thread guide to its
highest position. Rotate the shaft to the
left and right until each section "clicks" into
a locked position (fig. B).
6. Opening Front table
To open the front table, place your thumb
against the tab, and slide the cover to the
right. A slight pull toward you will allow
the cover to swing down, providing access
to the chain looper.
(fig. C).
Side Cover
Open side door on the left for easy access to
the chain looper thread tray.
Close door before sewing.
B
C
To Next Page
Loading...
Need help?
General
