1
2
3
4
5
6
section
4-6 Maintenance Menu Options
72
Unit Reset
This section describes methods used to reset specific parts of the device. This
involves the keyboard and mouse, the video display of the computer attached
to the RIPM, and the RIPM itself. To activate newly updated firmware, you must
reset the RIPM. This process automatically closes all current connections to
the administration console and to the RIPM, and takes only about 30 seconds.
Resetting sub-devices (e.g., the video engine) takes only a few seconds and
does not result in closing connections. To reset a specific RIPM, click on the
“Reset” button as shown in the image above.
Note: Only the administrator is allowed to reset the RIPM.
To Next Page
Loading...
Need help?
General